Adding/removing system components, Chapter – Rockwell Automation 6181 Industrial Computer User Manual
Page 45

Adding/Removing System
Components
This chapter describes how to remove and install:
•
back cover and top cover
•
add-in cards
•
CPU card
Note:
Instructions for removing and installing additional
components are included in additional chapters of this
manual:
•
Chapter 5, Installing/Removing the Power Supply
•
Chapter 6, Installing/Removing the Hard Drive, Floppy
Drive, or Expansion Bay
•
Chapter 8, Installing/Removing Memory Modules
The RAC6181 Computer contains line voltages. Make sure you
disconnect all power to the RAC6181 Computer before performing any
of the operations described in this chapter.
ATTENTION: Disconnect all power from the RAC6181
Computer before removing components. Failure to
disconnect power could result in severe electrical shock
or damage to the RAC6181 Computer.
Internal RAC6181 Computer components may be damaged by
Electrostatic Discharge (ESD). Make sure you wear a grounding strap
whenever handling circuit boards, memory modules or other internal
components.
ATTENTION: Wear a wrist strap (well grounded) and
perform work in a static safe environment.
Electrostatic discharge can damage the RAC6181
Computer and components.
Chapter
4
Chapter Objectives
Safety Precautions