Rockwell Automation 2755 StrataScan Bar Code Readers - Manual (Page 12)

1–6 Introduction to StrataScan Bar Code Readers
Publication 2755-6.13
8. Check the reader defaults, program as needed. Reference
Make sure you have DOS or Windows–based software on your personal computer. Run StrataSet
Programming software, Catalog No. 2755–LHS–1. Make sure that communications has been estab-
lished with your reader. e.g., read a test bar code to verify that the default settings are correct (i.e., the
reader is communicating with the configuration device). Program as needed. StrataSet
Programming
Software
Programming
Guide
(Pub. No.
2755–6.14)
9. Change configuration settings as necessary. Reference
If you need to set the reader to other than the default settings, refer to the software manual. Exit
Program mode and place the reader in Run mode. StrataSet
Programming
Software
Programming
Guide
(Pub. No.
2755–6.14)
10. Connect the system to host.
11. Run your application.