Add the digital output module – Rockwell Automation 1734-AENT, Series B POINT I/O EtherNet/IP Adapter Module User Manual User Manual

Page 71

Rockwell Automation Publication 1734-UM018B-EN-P - October 2013

Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software Chapter 5

Add the POINT I/O Modules and Configure for Rack-optimized
Connection

You must now add the ArmorPoint I/O modules to the I/O Configuration List
under the adapter. In this example, the digital input and output modules are
configured for rack optimization.

Add the Digital Output Module

1. Right-click the POINT I/O Chassis in the I/O Configuration folder and

select New Module

…

The Select Module Type dialog displays.

2. Select the appropriate filter for Module Type Category (for the example we

selected Digital) and Module Type Vendor (for the example we selected
Allen-Bradley).
Note: to select only one category you will need to unselect those already
selected.

3. From the modules listed select the 1734-OW2 digital relay output module

and click Create.

TIP

In the Select Module Type dialog, you have options to search for a
specific module, add modules to a Favorites list, filter by Category
and/or Vendor, Hide and Show Filters, use Module Discovery, sort by
vendor, or access your Favorites list.