Rockwell Automation 1732E-IB16M12SOEDR EtherNet/IP ArmorBlock supporting Sequence of Events - Manual (Page 44)

Publication 1732E-UM002A-EN-P - March 2010
36 Configure the Module Using RSLogix 5000
This screen is grayed out unless you are
online with the controller and module. On this
screen, you can:
A. Enable or disable external ports.
B. Select Auto-negotiate on enabled
ports. If Auto-negotiate is disabled
then select the correct speed and
duplex.
C. Click Port Diagnostics to display the
Port Diagnostics dialog.
D. If you make changes in Step A or
Step B then click Set. Changes will
not take effect until you reset the
module or cycle the power to the
module.
E. Click the Configuration tab to see the
next screen.
F. Click OK to close the Module
Properties dialog and download your
configuration.
On this screen, you can:
A. Set the Input Filter Times. For more
information on Input Filters, see page
46
B. Enable Timestamp Capture for all
input points or for specific points. For
more information on Timestamp
Capture, see
page 43 .
C. Enable Open Wire Detection for all
points or for specific points. For more
information on Open Wire Detection,
see
page 45 .
D. Click on the box to enable Timestamp
Latching. For more information on
Timestamp Latching, see
page 44 .
E. Click Refresh communication to
update the content.
F. Click OK to close the Module
Properties dialog and download your
configuration.
G. Click Help to access the RSLogix 5000
Add-On Profile help for descriptions of
tabs that are not required for setting
up your module.