Rockwell Automation 1732E-IB16M12SOEDR EtherNet/IP ArmorBlock supporting Sequence of Events - Manual (Page 42)

Publication 1732E-UM002A-EN-P - March 2010
34 Configure the Module Using RSLogix 5000
You can either accept or change the default configuration as shown...
Use the Default
Configuration If you use the default configuration and click on OK, you are done.
You can skip to Download Your Configuration on
page 37 for instructions on
downloading your default configuration to the controller.
Change the Default
Configuration If you click Change... in step D on page 34 , you can change the Module
Definition information. Select tabs on the Module Properties dialog to edit
specific configuration for your module in RSLogix 5000, for example the
Configuration tab.
Some of the screens that appear during this initial module configuration
process are blank and are not shown here. However, those screens can be
important during online monitoring. To see these screens in use, see Chapter
10, Troubleshoot the Module on
page 71
.
A. Name the module.
B. Enter the module’s IP address as shown.
C. Make sure the Module Definition
information matches this example.
D. Click Change... to edit the Module
Definition for your module before
downloading the program to the controller.
E. Click OK to accept the default
configuration.