Rockwell Automation 1732E-IB16M12SOEDR EtherNet/IP ArmorBlock supporting Sequence of Events - Manual (Page 31)

Publication 1732E-UM002A-EN-P - March 2010
Configure the Module for Your EtherNet/IP Network 23
The device is added to the Relation List, displaying the Ethernet
Address (MAC) and corresponding IP Address, Hostname and
Description (if applicable).
When the IP address assignment is made, the address displays in the IP
Address column in the Request History section.
4. To assign this configuration to the device, highlight the device in the
Relation List panel and click Disable BOOTP/DHCP. When power is
cycled to the device, it uses the configuration you assigned and not does
not issue a DHCP request.
TIP
To enable DHCP for a device that has had DHCP disabled,
highlight the device in the Relation List and click Enable DHCP.
You must have an entry for the device in the Relation List panel
to re-enable DHCP.