Rockwell Automation 1746-NI16V SLC 500 Analog Input Modules User Manual - Manual (Page 31)

Publication 1746-UM001A-US-P
Installation and Wiring 3-9
Terminal Wiring The 1746-NI16 module contains an 18-position, removable terminal
block. The terminal pin-out is shown below.
Terminal Block
Pre wired Cables and Terminal Blocks
The following 1492 cables and terminal blocks are available to assist
in wiring the 1746-NI16 module:
ATTENTION
!
Disconnect power to the SLC before attempting to
install, remove, or wire the removable terminal wiring
block.
To avoid cracking the removable terminal block,
alternate the removal of the slotted terminal block
release screws.
IN 0
IN 2
IN 4
IN 6
Analog Com
IN 8
IN 10
IN 12
IN 14
IN 1
IN 3
IN 5
IN 7
Analog Com
IN 9
IN 11
IN 13
IN 15
(Terminal Block Spare Part Catalog Number 1746-RT25G)
Terminal Block Release Screw
Maximum Torque = 0.7 to 0.9 Nm (6 to 8 in-lbs.)
Allen-Bradley Prewired
Cables 1492-ACAB005A46, 0.5m (1.6 ft.)
1492-ACAB010A46, 1.0 m (3.3 ft.)
1492-ACAB025A46, 2.5 m (8.2 ft.)
1492-ACAB050A46, 5.0 m (16.4 ft.)
Allen-Bradley User
Terminal Blocks 1492-AIFM8-3
1492-AIFM16-F-3