Rockwell Automation 1746-NI16V SLC 500 Analog Input Modules User Manual - Manual (Page 23)

1 Publication 1746-UM001A-US-P
Chapter
3
Installation and Wiring
This chapter tells you how to:
•
avoid electrostatic damage
•
determine the chassis power requirement for the module
•
choose a location for the module in the SLC chassis
•
install the module
•
wire the module’s terminal block
•
wire input devices
Hazardous Location
Considerations This equipment is suitable for use in Class I, Division 2, Groups A, B,
C, D or non-hazardous locations only. The following ATTENTION
statement applies to use in hazardous locations.
ATTENTION
!
EXPLOSION HAZARD
•
Substitution of components may impair suitability
for Class I, Division 2.
•
Do not replace components or disconnect
equipment unless power has been switched off.
•
Do not connect or disconnect components unless
power has been switched off.
•
This product must be installed in an enclosure.