Rockwell Automation 1775-KA PLC-3 Communication Adapter Module User Manual User Manual

User manual

Rockwell Automation 1775-KA PLC-3 Communication Adapter Module User Manual User Manual | 239 pages

Table of contents

Document Outline

1775-6.5.1, PLC-3 Communication Adapter Module User Manual
Table of Contents
1 - Introduction
- General
- About This Manual
- Module Description
- Specifications
- Applications
2 - Installation
- General
- Hardware Installation
- Programmable Configuration Parameters
- Backup Configurations
- Multiple 1775-KA Modules One PLC-3
3 - Data Highway Communication
- General
- Some Terminology
- Levels of Programming
- Data Transfers
4 - Addressing Rules and Examples
- General
- Number Systems
- Addresses
- Symbols
- PLC-3 Address Specifications
- PLC/PLC-2 Address Specifications
- Remote Station Address Specifications
- Expression
5 - Editing
- General
- Editing the Message Instruction
- Allocating Memory
- Editing Message Procedures
6 - Message Procedure Commands
- General
- Assignment Command
- CREATE Command
- DELETE Command
- Execute
- EXIT Command
- GOTO Command
- IF Command
- ON_ERROR Command
- STOP Command
- Functions
- Comments
7 - Error Reporting
- General
- Reporting Error Codes
- Recovery from Errors
- Error Monitoring
8 - Programming Examples
- General
- Individual Commands
- Message Procedure
9 - Computer to PC Communication
- Introduction to Layered Communication
- Full-Duplex vs Half-Duplex Protocol for the Data Link Layer
10 - Full Duplex Protocol
- General
- Definition of Link and Protocol
- Full-Duplex Protocol
11 - Half Duplex Protocol
- Half-Duplex Protocol
- Multidrop Link
- Transmission Codes
- Link-Layer Packets
- Protocol Environment Definition
- Half-Duplex Protocol Diagrams
- Line Monitoring
12 - The Network and Application Layer Protocol
- Network Layer
- Application Layer
A - Message Formats
B - Error Codes
C - Diagnostic Counter Block
D - Detailed Flowcharts
Index
Back Cover