Rockwell Automation 1775-KA PLC-3 Communication Adapter Module User Manual - Manual (Page 202)

Remote Error Codes Received from the
1773-KA Module
Appendix B
BĆ10
Error Error
Code Type Meaning
169 local Either the number or the expression following the
'/' in an address has a value outside the range 0 to
15 (decimal).
171 local Value specified in a bit assignment statement was
other than a zero or a one.
177 local Illegal use of EXIT command.
178 local Illegal use of STOP command.
179 local STOP encountered in procedure.
188 local Attempt to read/write at bad address.
189 local Unable to evaluate the expression in the given base.
This will occur, for example, if the argument of a
FROM BCD function is not a valid BCD bit
pattern. It will also occur when invalid characters
occur in numeric values (e.g., 57 + 12X").
192 local Function being used is not defined.
194 local Expression is too complex.
199 local Attempt to divide by zero.
200 local Bad port specifier. That is, the character following
the '#' is other than 'H', 'h', 'M', or 'm'.
201 local User symbol used as part of remote address
specification.
202 local Undefined data following assignment command.
This error would occur, for instance, if the modifier
UNRPOT were used instead of UNPROT.
203 local Error in remote specification.
1.A character other than '@' or 'following the
station number specification (...=#H045*T...).
2.Something other than EOL, PROT, or UNPROT
following a remote source address
(...=#H012$S5:8 + 9).
204 local Third-party transfer. That is, in an assignment
command, both the source and the destination were
remote addresses.
205 local Error in evaluating a PLC-2 address, or PLC-2
address greater than 65,535.
206 local Zero range specified in an assignment command.