Rockwell Automation 1771-ACNR15 CONTROLNET ADAPTER MODUL - Manual (Page 18)

2–4 Installing Your ControlNet Adapter Module
Publication 1771-6.5.124 – August 1997
The switches on the top of the adapter module determine the network
address of the adapter. The two switches are:
•
the ten’s switch
•
the one’s switch
The combination of these switches allows selection of network
addresses from 01 to 99.
Use a small bladed screwdriver to rotate the switches.
Figure 2.2
Setting the Network Address
Ten’s Selection One’s Selection
Ten’s Selection One’s Selection
NET ADDRESS
10 5 = 15 plus
For example, the 10’s selection switch is set to 10,
and the 1’s selection switch is set to 5.
NOTE: 00 is an invalid number.
Then,
Setting the Network
Address Switches