Rockwell Automation 1746-MPM INSTALL INSTRUC MOLD PRESSURE - Manual (Page 2)

2 Mold Pressure Module
Publication 1746-5.13 July 1998
Recommendation for using associated software
We recommend the following software to use this module effectively:
• To display molding parameters processed by the module,
your personal
opuer us e euppe n soare
ro ! enolo"es# $n% ra&erse y# ’$
. For instructions
on using the software, refer to DARTWin Software Installation and Use
manual.
• To program the SLC processor to interface the module with molding
machine operation, your PC should be equipped with programming
software RSLogix 500™ from Rockwell Software. For instructions on
using the software, refer to the documentation that accompanied it.
What you need to do to set up and operate the module
This document covers installing, powering up, and operating the module.
Section Description Page
1 what the module does 3
2 wire module I/O 4
3 module I/O 5
4 configure the module with jumper plugs 7
5 configure the SLC processor’s I/O, G file, and M0/M1 files 8
6 set sensor inputs to zero 11
7 check channel operation 11
8 write ladder logic 12
9 troubleshoot the module 15
10 use DartWin software to display processed data 15
11 listing of M0/M1 file words 16
12 specifications 18
13 compliance with European Union directives 19
14 CSA hazardous location approval 20