Rockwell Automation 1746-MPM INSTALL INSTRUC MOLD PRESSURE - Manual (Page 19)

Mold Pressure Module 19
Publication 1746-5.13 July 1998
13. Compliance with European Union Directive
If this product has the CE mark it is approved for installation within the
European Community or EEA regions. It has been designed and tested to
meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EC
Electromagnetic Compatibility (EMC) and the following standards, in
whole or in part, documented in a technical construction file:
• EN 50081-2
EMC - Generic Emission Standard, Part 2 - Industrial Environment
• EN 50082-2
EMC - Generic Immunity Standard, Part 2 - Industrial Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage,
by applying the safety requirements of EN 61131-2 Programmable
Controllers, Part 2 - Equipment Requirements and Tests. For specific
information required by EN 61131-2, see the appropriate sections in this
publication, as well as the Industrial Automation Wiring and Grounding
Guidelines for Noise Immunity, publication 1770-4.1.
This equipment is classified as open equipment and must be mounted in
an enclosure during operation to provide safety protection
.