Rockwell Automation 1302 575v AC Drive - Canada Only - Manual (Page 23)

3–5 1302 Preinstallation
Publication 1302-5.0 — January, 1998
Table 3.B - Recommended Power Wire Sizes
Type of Wiring Terminals
Size of Wire
(maximum)*
AC Input Power R(L1), S(L2), T(L3) 14 AWG, 2 (mm 2 )
Output Power U(T1), V(T2), W(T3) 14 AWG, 2 (mm 2 )
DC Bus ć , + 14 AWG, 2 (mm 2 )
Snubber Resistor +10 VDC, 10 COM 14 AWG, 2 (mm 2 )
Ground GND 14 AWG, 2 (mm 2 )
Table 3.C - Recommended Power Terminal Tightening Torque
Drives Terminals Maximum Tightening Torque
All All power wires 1.08 NewtonĆmeters (9.5 inĆlb)
Recommended Control and Signal Wire Sizes
Table 3.D shows the recommended wire sizes to connect I/O signals
to the terminal strip on the Regulator board. The minimum wire
insulation rating is 600V. Operator controls can be up to 303 meters
(1000 feet) from the 1302 Drive. All signal wires should be
twisted-pair.
Table 3.D - Recommended Control and Signal Wire Sizes and Tightening Torque
Drives Terminals
Minimum
Wire Size
Maximum
Wire Size
Maximum
Tightening Torque
All 1ć16 20 AWG, 0.5 (mm 2 ) 14 AWG, 2 (mm 2 ) 0.5 NewtonĆmeters
(4.5 inĆlb)