Rockwell Automation 1302 575v AC Drive - Canada Only - Manual (Page 19)

Chapter
3
3–1
Publication 1302-5.0 — January, 1998
1302 Preinstallation
Chapter 3 provides information that you must use when planning a
1302 AC Drive installation. Installation site, wiring and motor
application requirements are included in this chapter.
!
ATTENTION: The following information is merely a
guide for proper installation. The National Electrical
Code and any other governing regional or local code
will overrule this information. The Allen–Bradley
Company cannot assume responsibility for the
compliance or noncompliance to any code, national,
local or otherwise for the proper installation of this
Drive or associated equipment. A hazard of personal
injury and/or equipment damage exists if codes are
ignored during installation.
ATTENTION: Hazard of electric shock or equipment
damage exist if the Drive is not installed correctly. The
National Electrical Code (NEC) and local codes outline
provisions for safely installing electrical equipment.
Installation must comply with specifications regarding
wire types, conductor sizes, branch circuit protection
and disconnect devices. Only qualified electrical
personnel familiar with the construction and operation
of the 1302 Drive and the hazards involved should
install, adjust, operate, or service this equipment. Read
and understand this manual and other applicable manu-
als in their entirety before proceeding. Failure to do so
may result in personal injury and/or equipment
damage.
!
General