Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 98)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 98 of 108
% % % " ($
WI Series transfers the configuration information between your PC and the module using a
serial port.
Note
You must set the serial port before transferring the configuration. For more information,
see Setting the serial port on page 95.
To load the configuration information (i.e. transfer the information from the module to the
PC):
1. Open the project.
2. Select the unit you want to load.
3. Click Load Unit .
4. WI Series checks you want to read the configuration from the module:
5. Click Yes to read the configuration from the module or click No to quit without loading.
Note
If the address of the module you are loading from does not match the address of the unit
configuration you are reading to, WI Series shows the following warning.
This helps ensure that you program the correct module.
Check that the module that you are loading is correct. If this is the correct module, click
OK to continue configuring the module. If you have connected to the wrong module,
click Cancel to return to the previous screen so that you can connect the correct module
and repeat the loading operation.
If you click OK the configuration of the module is loaded into the unit configuration.