Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 14)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 14 of 108
This section describes how to configure your WI-I/O 9-L.
Note
For more information on installing your WI-I/O 9-L, please see the WI-I/O 9-L Installation
Guide .
You can configure your network using:
User-defined (customized) configuration – that lets you set specific information
about your network and allows communication with other Weidmuller, Inc. I/O modules.
Default factory configuration – that lets you use a transmitter and receiver as a
simple send/receive pair.
This manual describes how to perform custom configuration to:
Fully utilize of the features of the WI-I/O 9-L modules; and
Communicate between WI-I/O 9-L modules and other Weidmuller, Inc. I/O modules.
For more information on restoring the default configuration (i.e. linking), refer to the Quick
Start Guide included with your module.
The following tables detail the default settings:
Setting Default
Periodic transmission Every second
Analog sample rate 5 samples per second
Analog change of state sensitivity 3%
Output state on comms failure Reset to zero
Analog setpoints Set by rotary switch (switch value x 10%±5%)
Analog Input debounce 1 sample
Digital input debounce time 0.5 seconds
Signals sent over radio
WI-I/O 9-L-T(Transmitter) Sends WI-I/O 9-L-R (Receiver)
Digital Input 1 Digital Output 1
Digital Input 2 Digital Output 2
Analog Setpoint Digital Output 3
Analog input (4-20 mA) Analog output