Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 96)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 96 of 108
( " ! % % % ($
"
WI Series transfers the configuration information between the module and your PC using a
serial port.
Note
You must set the serial port before loading the configuration. For more information, see
Setting the serial port on page 95.
To program the unit (i.e. write the information form the PC to the module):
1. Open the project.
2. In the tree view, select the unit you want to program.
3. Ensure the module is powered on and the serial cable connected
4. Click Program Unit .
5. WI Series checks you want to write the configuration information to the module:
6. Click Yes to write the configuration information to the module or click No to return to the
previous screen without writing the configuration information.
Note
If the system address of the module you are programming does not match the address
of the configuration that you are sending, the following warning is displayed:
This helps ensure you program the correct module.
Check the module you are programming should be added to your system. If this is the
correct module, click
OK to continue configuring the module. If you have connected to
the wrong module, click Cancel to return to the previous screen and connect the correct
module and repeat the programming operation.