Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 97)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 97 of 108
Note
If the unit address of the module you are programming does not match the address of
the configuration that you are sending, WI Series shows the following warning:
This helps ensure that you program the correct module.
Check the module that you are programming should have its unit address changed. If
this is the correct module, click
OK . If you have connected to the wrong module, click
Cancel to return to the previous screen and connect to the correct module and repeat
the programming operation.
7. WI Series writes the configuration information to the module.
8. Once configuration is complete, you should remove power and re-start the module to
enable the new configuration.
Note
If you are programming a module with manually-set analog calibration, and that module
has been set to factory configuration, WI Series lets you select between using the
factory analog calibration or retaining the manual analog calibration.
If the manual analog calibration contains values you want to use, click No to continue
using the manual calibration; otherwise click Yes to reload the factory calibrations or
click Cancel to return to the previous screen without configuring the module.
If you click Yes the manual analog calibration values will be overwritten and cannot be
recovered.