Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 18)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 18 of 108
WI Series lets you configure units using a configuration software program. The configuration
software runs as a Windows application on a PC and lets you:
Create a configuration file – that contains specific information for all units in the
system including WI-I/O 9-L units;
View and change the configuration information – as required;
Program the configuration information – to each of the WI-I/O 9-L modules via the
RS-232 cable; and
Load the configuration information – from each of the WI-I/O 9-L modules via the
RS-232 cable into the configuration file.
WI Series lets you:
Task Description For more information,
see …
Installing the
configuration software
To configure your modules, you must install the WI
Series software.
Installing the
configuration software
on page 19.
Start WI Series Lets you work with your module to communicate and
transfer information between the module and your PC.
Starting WI Series on
page 19.
Exit WI Series Lets you close the software for communicating and
transferring information between the module and your
PC.
Exiting WI Series on
page 20.
Check your
configuration software
version
Lets you identify the current version of software in use.
This information is important for contacting Weidmuller,
Inc. if you have support issues.
Checking the current
configuration software
version on page 20.
For more information, see the next sections.