Talos Security DR08 DVR Manual - Manual (Page 71)

Digital Video Recorder User Manual
56
Chapter 6 Remote Surveillance
6.1 IE Remote Surveillance
In order to view the DVR from network, it must be connected to a LAN/WAN or
Internet. The following introduces the connection and use of Internet. Remote access
to the Internet has two types according to their online behavior.
6.1.1 On LAN
Step 1: Right-click "My Network Places" to pop-up a drop-down menu, then click
"Properties" to open the "Network connection".
Step 2: Double-click
“Local Area Connection ", then click "Properties" button.
Step 3: Double-click "Internet Protocol (TCP / IP) ”.
Step 4: Obtain IP address, subnet mask and gateway of local computer.
Step 5: Set the IP address, subnet mask and gateway of DVR.
Enter into the DVR’s Main MenuSetupNetwork configuration to enter IP address,
subnet mask and gateway. Subnet mask and gateway must be same as the
parameters of “Internet Protocol”, and IP address should be in the same field as your
computer.
E.g. if your computer is 192.168.1.8, then the IP address of DVR can be 192.168.1.X
(
“X” is an arbitrary integer between 0 and 255 in addition to 8 and 1), subnet mask is
255.255.255.0, and gateway is 192. 168. 1. 1.
Step 6: After finish the above settings, input the IP address of DVR in browser
address bar to enter the login page , such as: 192.168.1.X. The network will download
control automatically (the settings of browser must allow to download control, refer to
Appendix -1).
Step 7: After the download is complete, interface will pop up a login window.