Steriflow JSRLP Series - Manual

Steriflow by Jordan Valve
3170 Wasson Road • Cincinnati, OH 45209
513.533.5600 • 800.543.7311 • 513.871.0105 (f)
[email protected] • www.steriflowvalve.com
JSRLP Series
Low Pressure Reducing Valves for Bio-Pharm Gas Applications
JSRLP is a high purity gas low pressure regulator designed
and built specifically for hygienic, ASME BPE gas applications.
The JSRLP has been designed specifically for low pressure
clean gas regulation in Stainless and Single use disposable
applications. Whether it's precise regulation for sparging,
blanketing, motive force, or SUD bag inflation, the JSRLP
was built for the job!
The durable valve body and metal trim components are
machined from ASTMA479 316L SST barstock and finished
to ASME BPE SF5 (20Ra micro-inch, electropolished) stan-
dard. The valve is outfitted with a thin Jorlon diaphragm and
Teflon, PEEK, or EPDM seats and seals that are all FDA
approved, USP Class VI compliant materials. These materi-
als of construction enable JSRLP to withstand the rigors of
an autoclave if required. The EPDM seat reduces lockup to
less than 0.5 psig on this model.
F
eatures
• No exposed threaded connections below diaphragm
• In-line removable seat and trim facilitate cleaning and
routine maintenance
• Barstock construction guarantees material integrity and
surface finish
• Very low lockup with EPDM seat material
• High rangeability and relatively low set point offset
lessens the need for reduced trim sizes
• Minimized internal volume
• Proprietary Jorlon diaphragm material provides excep-
tionally long life and Autoclave capability
• Soft seat material for ANSI Class VI shutoff
• Can be used on continuous clean steam, and on
non-cavitating fluids
D
ocumentation
• The following documentation is shipped at no charge:
• Steriflow Unicert:
• Certificate of Compliance for:
- Material, including MTR’s
- Surface Finish
- FDA/USP Class VI
• Traceability:
- Each Unicert includes individual valve serial
numbers, heat numbers and attached MTR’s directly
traceable to the valve serial number and heat numbers
imprinted on all wetted metallic components.
s
urFace Finish
• ASME BPE SF5 (20 Ra micro inch,
electropolished) – standard for all exter-
nal and wetted metal parts
• Other finishes optional
• O
2
cleaning - optional
a
pplications
Ideal for clean gases used in bio-pharma-
ceutical, and pharmaceutical process.
Designed specifically for low pressure con-
trol on traditional Stainless Steel and Single
Use Disposable installations such as: Air or
gas overlay, pressure filling, Lyophilization,
sparging, or SUD bag inflation.
• Clean Filter Air
• Nitrogen
• Carbon Dioxide
• Argon
• Oxygen
• Custom purge or blanket gas
Sanitar
y V
alv
es
JSRLP
Series Low Pressure Reducing
V
alv
es