Steriflow Mark 93 Series - Manual

Mark 93 Series
Sanitary Steam Traps
STERI FLOW TM by Jordan Valve
3170 Wasson Road • Cincinnati, Ohio 45209
Telephone 513.533.5600 • Fax 513.871.0105
Toll-Free Telephone: 800.543.7311
[email protected] • www.steriflowvalve.com
The Mark 93 is a balanced port, thermostatic steam
trap designed specifically for use in validated clean
steam systems. The sanitary design follows ASME BPE
guidelines including a 20Ra
µin internal finish, self-
draining design, and all relevant materials, marking
and documentation guidelines.
The MK93 has been specifically designed to provide
higher flow rates at low pressures and low subcooling
levels. In lab testing, the MK93 consistently exhib-
ited excellent flow rates at subcooling levels of less
than 3°F or less (<1,7°C). Note: Low subcooling op-
eration insures that condensate won’t back up and wet
(cool) the upstream validated temperature sensor.
There are two base designs within the MK93 product
range: the standard MK93 – good for inlet pressures
(P1) up to 50 psi (3,4 bar), and the MK93 Option “P”
for inlet pressures ranging from 45 – 90 psi (3,1 – 6,2
bar). Both designs are rated to 90 psi (6,2 bar) operat-
ing pressure but are recommended for use within the
specified inlet pressure ratings.
During start-up, the bellows element is contracted and
fully open to discharge all non-condensable gas and
condensate. The heat of entering steam causes the
element to expand, closing the valve. As condensate
accumulates in the body, the element cools, causing the
bellows/stem tip to retract allowing condensate to drain.
Features
• Low subcooling operation reduces probability
of temperature validation faults and resultant SIP
delays
• CRN Registration Number available
• Thermostatic steam trap in 316L stainless steel that
is designed for clean steam tracing, drip-leg and
process applications
• All 316L stainless steel housing and internals
• Polished components – body interior and exterior
are mechanically polished to 20Ra finish
• Sanitary clamp ends standard, other ends (tube
weld, threaded, ISO/DIN) available upon request
• Self draining when installed vertically (outlet side
down)
• New design provides excellent flow rates with low
subcooling
• FDA and USP Class VI TFE-VIT gasket stan-
dard on clamped body, or FDA and USP
Class o-ring on bolted option
• Option for electropolished body
• Warranties:
– 5 year material and workmanship
– 2 year low subcooling performance
Applications
• Typical applications are: sterilization drain-
age for fermenters, bioreactors, separa-
tion and filtration equipment, lyophilizers,
autoclaves, process piping equipment and
steam barriers
• Condensate drainage from process sys-
tems using clean steam – fermenters,
bioreactors, SIP systems and sterilizers
Sanitar
y V
alv
es Mark
93
Sanitar
y Steam
Traps
NEW! Horizontal
connections
available