beautypg.com

Sensaphone 800 User Manual

Page 95

background image

Chapter 6: Acknowledgment, Status Report & Remote Access

93

6 .2 .4 Battery Condition

During a Status Report, you may hear one of three possible
messages regarding battery power. The Model 800 determines the
appropriate message by measuring battery voltage. Depending
upon the remaining voltage, it may respond:

“The batteries are OK,” if over 8.2 Volts.

“The batteries are low,” if between 7.2 and 8.2 Volts.

“Replace batteries,” if below 7.2 Volts.

6 .2 .5 Remote Access by Touch-Tone™ Telephone

You can issue a number of commands to the 800 remotely using
a Touch-Tone

telephone. This command mode can be entered

at any time during the status report. Simply press a Touch-Tone

and the unit will halt the report and respond with “OK.” You are
now in Touch-Tone

command mode. Commands are available

to perform the following functions:

• Enable and disable zones, power monitoring, and sound
monitoring

• Recite/Set High and Low alarm limits

• Recite/Set telephone numbers

• Record/Play custom voice messages

• Recite/Set the relay output

• Activate the microphone for listen-in

• Recite status report

NOTE: If a security code is enabled, the 800

will prompt you with “Enter security code.”

Enter the four-digit keypad security code plus

#” to enter touch-tone command mode. If

entered correctly, the 800 will respond with

“OK” and you can proceed to enter the com-

mands. If entered incorrectly, the unit will give

you one more chance. If it is incorrect a second

time, the unit will say “Error, goodbye” and

hang up.