Sensaphone 800 - Manual (Page 93)

Chapter 6: Acknowledgment, Status Report & Remote Access
91
“Listen to the sound for 10 seconds.” In this case, the
programmed Listen-in Time is set at 10 seconds. (This feature is
not available when obtaining the Status Report on-site, directly at
the keypad.)
The Status Report repeats once more and the Model 800
concludes the call, saying: “Goodbye.” (The Status Report will
not repeat if obtained at the keypad; “Goodbye,” is also not
recited.)
The phrase “no number” at the end of a Status Report indicates
that no dial-out phone numbers have been programmed.
6 .2 .2 Example: Status Report, Existing Alarms
Zones 2, 3, 4, 5, 6, 7 and 8 are configured as dry contact and
zone 1 is configured as temperature. An emergency situation is
at hand: a fire in a greenhouse has tripped a smoke alarm and
electrical power has been disrupted. In addition to high sound and
AC power alarms, separate alarms exist on zones 1, 2, 3, and 4.
You happen to call in for the Status Report, which begins with,
Hello, this is 555-1234; “this is the Sensaphone 800 at ACME
Greenhouse, 225 Oak Street”
It is now 8:45 PM
Zone 1, “Temperature in greenhouse”, 110 degrees Fahrenheit,
too high, acknowledged alarm exists
Zone 2, “Door alarm in greenhouse”, not OK, acknowledged
alarm exists
Zone 3 “Water pressure alarm in greenhouse”, not OK,
acknowledged alarm exists
Zone 4 “Greenhouse control system”, not OK, acknowledged
alarm exists
Zone 5 “Emergency generator alarm”, not OK, acknowledged
alarm exists
Zone 6, OK
Zone 7, OK
Zone 8, OK
A High Sound alarm exists, it is now too high
The Power is Off.
The Batteries are Low.