Sensaphone 800 User Manual
Page 94
Sensaphone
®
Model 800 User’s Manual
92
The Output is Off.
Listen to the sound for 10 seconds.
Goodbye.
6 .2 .3 Example: Status Report, Disabled Zones
If a zone is disabled, the dial-out feature for that zone is
deactivated, but all other programmed parameters remain in
effect. In the example below, all 8 zones are disabled, although
zones 1 and 3 are detecting alarms. AC power and Sound Level
are also disabled for dial-out. When you call the Model 800 for a
Status Report, you hear the following:
Hello, this is 555-1234; “this is the Sensaphone 800 at ACME
Greenhouse, 225 Oak Street”
It is now 8:45 PM
Zone 1, “Temperature in greenhouse”, the alarm is disabled, it
is now 110 degrees Fahrenheit, too high, acknowledged alarm
exists.
Zone 2, “Door alarm in greenhouse”, the alarm is disabled, it is
now not OK, acknowledged alarm exists.
Zone 3 “Water pressure alarm in greenhouse”, the alarm is
disabled, it is not OK.
Zone 4 “Greenhouse control system”, the alarm is disabled, it is
not OK.
Zone 5 “Emergency generator alarm”, the alarm is disabled, it is
not OK.
Zone 6, the alarm is disabled, it is now OK
Zone 7, the alarm is disabled, it is now OK
Zone 8, the alarm is disabled, it is now OK
The Sound alarm is disabled, it is now too high
The Power alarm is disabled, it is now Off.
The Batteries are Low.
The Output is On.
Listen to the sound for 10 seconds.
Goodbye.
The Status Report repeats once more and the Model 800
concludes the call, saying: “Goodbye.”