Sensaphone 800 User Manual
Page 92
Sensaphone
®
Model 800 User’s Manual
90
2. Press STATUS.
STATUS
Sections 6.2.1, 6.2.2, and 6.2.3 demonstrate two different Status
Report recitations. The Status Report starts with:
“Hello. This is 555-1234 (or the programmed ID), (Custom ID
Message).”
“It is now 12:15
pm
(or the current time).”
The Model 800 proceeds with a separate report for each zone.
Each zone identifies itself by reciting the zone number and it’s
associated voice message.
6 .2 .1 Example: Status Report, No Alarms
Zones 2, 3, 4, 5, 6, 7, and 8 are configured as dry contact and
zone 1 is configured as temperature. No alarms exist. The Status
Report begins by saying, “Hello, this is 555-1234, this is building
M, third floor; it is now 2:30
pm
.”
Following this introduction, the report continues:
“Zone 1, room temperature, 74 degrees, OK.”
“Zone 2, door alarm, OK.”
“Zone 3, ups alarm, OK.”
“Zone 4, water sensor, OK.”
“Zone 5, OK.”
“Zone 6, OK.”
“Zone 7, OK.”
“Zone 8, OK.”
“The sound is OK.”
“The power is ON.” This refers to AC power.
“The batteries are OK.” Other possible responses: “Batteries
are low” or “Replace batteries.” (Refer to Section 6.2.4 for
additional information regarding battery condition.)
“The output is off.”