Sensaphone 800 - Manual (Page 73)

Chapter 5: Alarm Programming
71
5 .1 .2 Interrogating Zone Configuration
1. Press WHAT IS.
2. Press CONFIG.
The Model 800 will audibly recite the configuration of each zone.
5 .2 Enable/Disable Zones
This function allows you to enable or disable a zone’s response
to an alert condition. An enabled zone will respond to an alert
condition and allow dial-out. A disabled zone will cause dial-out
to be suppressed, but any existing alert conditions will be revealed
during the Status Report. Enable/disable programming is useful
during wiring of zones (see Chapter 2) or when a condition needs
to be monitored, but is not critical enough to be programmed
for dial-out reporting. It is important to verify zone status after
performing any task that requires disabling. The default setting
for all zones is enabled (ON).
If an alert condition exists when zones are re-enabled,
Recognition Time will restart—refer to Section 5.3.
5 .2 .1 Changing Enabled/Disabled Zone Status
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press the number (1 to 8) of the selected zone to enable/
disable. The Model 800 says “Alarm Disabled” to indicate
disabled or “Alarm Enabled” to indicate enabled.
4
MAX CALLS
5
TEMP LIMITS
6
CALIBRATE
8
CLOCK
3
INTERCALL
TIME
7
RECOGNITION
TIME
9
LISTEN TIME
SOUND
0
ID NUMBER
POWER
1
CALL
DELAY
2
VOICE
REPS
5 .2 .2 Verifying Enabled/Disabled Zone Status
1. Press WHAT IS.
WHAT
IS
WHAT
IS
CONFIG