Sensaphone 800 User Manual

Page 56

Sensaphone

Model 800 User’s Manual

4 .6 .4 Special Dialing to a Beeper or Pager

Your Sensaphone can be programmed to send an alarm message
to a numeric beeper/pager. The message will include the
Sensaphone’s telephone number (ID number) and the Zone
numbers that are in alarm. For example, if zones 1 and 4 are
in alarm, the message on your pager would be: 8882227777-1-
4, where 8882227777 is the unit’s ID number. A Sound alarm
will appear as alarm -9 and a Power alarm will appear as alarm
-0. To program a telephone number for Pager dialout, you must
enter Code 1 at the beginning of the telephone number. The
Sensaphone will say “Code one, Pager” when you enter the
command.

Follow the key sequence below to dial a numeric pager:

SET + PHONE NUMBER + any unassigned number key 1-8 +

CODE + 1 + pager telephone number + ENTER

To check your programming:

WHAT IS + PHONE NUMBER + assigned # 1-8

The Sensaphone will say “Pager”, followed by the programmed
telephone number.

To send a test page:

SET + TEST + assigned # key 1-8 + ENTER

The Sensaphone will let you listen to the dialout sequence
through its speaker and send you a message that includes the
Sensaphone’s telephone number (ID number).

Voice Prompted Paging Systems

If your paging provider is answered by a voice prompt which
requires you to enter one or more touch-tones to send a message,
then use the wait-for-answer code (4.5.1) in combination with
the Pause key and other number keys to navigate the voice menu
until you reach the message entry point. The Sensaphone will
automatically send it’s telephone number, Zone numbers, and a
pound (#) tone at the end of the number. For assistance contact
Sensaphone Technical Support at 1(877)373-2700.