Sensaphone 800 - Manual (Page 61)

Chapter 4: Communications Programming
59
4 .9 .2 Interrogating the Listen-in Time
To interrogate the Listen-in Time:
1. Press WHAT IS.
WHAT
IS
2. Press LISTEN TIME. The Model 800 will recite the listen-in
time.
9
LISTEN TIME
SOUND
4 .10 Call Delay
Call Delay is the programmed length of time the Model 800
waits, following detection of an alarm, before it begins the dial-
out sequence. This applies only to the first call. (Delay time
between calls is also programmable: refer to Intercall Time,
Section 4-12.)
The purpose for Call Delay is to allow time for personnel at the
Model 800’s installation site to respond to and cancel an alarm
before dial-out begins. During this time, the Model 800 will
audibly repeat its “alarm” message (unless the Local Voice Mute
feature has been activated—refer to Section 4.10). The default for
Call Delay is 30 seconds. Call Delay can be programmed from 0
seconds to 60 minutes (1 hour).
4 .10 .1 Programming the Call Delay
To program the Call Delay:
1. Press SET.
SET
2. Press CALL DELAY.
1
CALL
DELAY
The Model 800 will respond: “Enter minutes.”