Prescolite SOCKET POSITION ADJUSTMENT User Manual

Instruction sheet

Instruction

Sheet

www

.prescolite.com

• Prescolite

TollFree

Technical Support

1.888.PRS.4TEC

• Hours: 8am - 5pm ET

101 Corporate Drive• Spartanburg, SC 29303

With representatives offices in principal cities throughout North America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .03975500

Instruction

Sheet

INSTALLATION INSTRUCTIONS

SOCKET POSITION ADJUSTMENT

1145-362/3

1136-362/3

1165-362/3

SOCKET BRACKET

(INVERTED ON

SOME UNITS)

To adjust the socket, loosen the wing nut and slide the socket bracket up or down to the proper position

for the recommended lamp per the chart below. Tighten wing nut to secure bracket in position.

TYPICAL

SUPPORT BRACKET

DOWN

WING NUT

CAT. NO.

SOCKET POSITION

LAMP

1147-662/3

1140-662/3

1167-662/3

1146-462/3

1138-462/3

1166-462/3

100W A-19

300W PS-30

300W PS-25

200W A-23

150W A-21

DOWN

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information

and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,

and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and

during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by

qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.

Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in

compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by

the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from

product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or

the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.