Instruction sheet, Assembly and installation instructions – Prescolite RMNICDAT User Manual

Page 3

Instruction

Sheet

www

.prescolite.com

Prescolite T

ollFree T

echnical Suppor

1.888.PRS.4TEC

Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Part No ....................................................... 93021951

Sheet 3 of 3

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions concerning Wet or Damp

Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible vapors or gases.

Before wiring to power supply and during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed

by qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard. Product must be

mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with the National Electrical

Code and local building codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an

unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains,

screens or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.

Note:
Make sure surface area is clean and dry before applying gaskets to can.

1. To convert the RMNICD to an Airtight Unit, use the following Gasket Components to seal openings in the Housing (1) as shown.
(A)- 1"x 1/2" Gasket, Qty. 1 (APPLY BEFORE INSTALLATION)
(B)- 1/2"x 1/2" Gasket, Qty. 2 (APPLY BEFORE INSTALLATION)
(C)- 5"x 1/2" Gasket, Qty. 2 (APPLY TO INSIDE OF CAN AFTER INSTALLATION)
(D)- AIR-TIGHT label (160060100 not shown), Qty. 1 (APPLY TO INSIDE OF CAN BEFORE INSTALLATION)

Note:
160060100 is pre-installed at factory on rMNiCDAt. label in kit can be discarded.

ASSEMBly AND iNStAllAtioN iNStruCtioNS

CAutioN: read instructions carefully and turn electricity off at main

circuit breaker panel before beginning installation.

***************************************************************************************

WARNING: IF ANY SPECIAL CONTROL DEvICES ARE USED WITH THIS FIxTURE, FOLLOW THE INSTRUCTION

CAREFULLY TO ASSURE FULL COMPLIANCE WITH N.E.C. REQUIREMENTS. IF THERE ARE ANY QUESTIONS,

CONTACT A QUALIFIED ELECTRICAL CONTRACTOR.

***************************************************************************************

GK6