Prescolite 9RALT - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .02381600
Instruction
Sheet
INSTALLATION INSTRUCTIONS
TRIM INSTALLATION:
6FPR, 6FDOP, 6FFR,
9FPR, 9FDOP, 9FFR, 9RALT
Torsion Spring
Bracket (2)
Engage Trim Torsion
Springs Here
Trim
Stud Fastener
Torsion Spring
Bracket
Torsion Spring (2)
Fig. A
Fig. B
Housing
Housing
LFIL6HSQ, LFIL9HSQ
(LFIL6HSQ Illus.)
6FPR, 6FDOP, 6FFR,
9FPR, 9FDOP, 9FFR,
9RALT (6FDOP Illustrated)
1/4" Diameter
Lower Hole
Upper Hole
TRIM INSTALLATION
1. Obtain from Packet two torsion spring brackets and two stud fasteners. Assemble
fasteners to brackets by pressing stud through bracket as shown in Fig. B.
2. Install torsion spring brackets by hooking tab into upper hole in housing and pressing
stud into 1/4" diameter lower hole, Fig. B.
3. Place trim torsion springs into slots in torsion spring brackets as shown. Push trim up
into housing and allow torsion springs to pull trim up against ceiling.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.