Instruction sheet, Prs.4tec – Prescolite LVH4IC User Manual
Page 2

www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06286800
Instruction
Sheet
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 09/05 revision, All Rights Reserved - Printed in U.S.A.
Frame-In
Place housing between joists, line-up self-leveling
tabs with bottom of joists as shown and hammer
integral forked nailing tabs into joists.
Leveling Tab
Electrical Wiring
Warning: Disconnect power before wiring fixture
to the circuit.
Use one of the knock-outs provided in the J-Box
for supply wire entry. Remove J-box cover
plates and make electrical splices, black to
black, white to white and ground wire to green
ground wire in J-Box. Push splices in J-Box and
replacce covers.
Electrical Rating of Fixture
LVH4120: Primary 120V. .5 AMPS
Secondary: 12V. 50VA. MAX.
Close-Up
Install plasterboard
1
/
2
” to 1” Max. Cut a 4
3
/
8
” Dia. Hole in board at desired location for mounting frame trim flange.
Suspended Ceilings
Make sure that the bottom of the mounting frame is no higher than 1” above ceiling line.
Junction
Box
CAUTION
When installing trim in housing, make sure
power and socket leads are not resting on lamp
or trim surfaces.