Instruction sheet – Prescolite MH4A User Manual
Page 2

www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .03962900
Instruction
Sheet
Junction
Box
Frame-In
Place housing between joists, line up self-leveling
tabs with bottom of joists as shown and hammer
integral forked nailing tabs into joists.
Leveling Tab
Electrical Wiring
Warning: Dissconnect power before wiring fixture
to the circuit.
Use one of the knock-outs provided in the J-Box
for supply wire entry. Remove J-Box cover plates
and make electrical splices: black to black, white
to white and ground wire to green ground wire in
J-Box. Push splices in J-Box and replace covers.
Close-Up
Install plasterboard 1/2” to 1” Max. Cut a 41/8” Dia. hole in board at desired location for mounting frame trim
flange.
Suspended Ceilings
Make sure that the bottom of the mounting frame is no higher than 1” above ceiling line.
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 09/05 revision, All Rights Reserved - Printed in U.S.A.