Prescolite TA 4B/C/G & BF - Manual (Page 2)

www.prescolite.com
•
Prescolite
TollFree
Technical
Support
1.888.PRS.4TEC
•
Hours:
8am
-
5pm
ET
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 05487600
Instruction
Sheet
2. When desired aiming angle is accomplished, lock yoke in placce by tightening hex socket screw located on inside of cone or baffle: turn
wrench clockwise to tighten, counterclockwise to loosen.
Note: Trim does not require removal from housing for adjustment.
3. Push trim all the way up into housing aperture until flange seats flush against ceiling.
Hex Socket Button Head
Cap Screw
45°
AIMING THE LAMP
1. Trim may be manually rotated 360° and yoke tilted 45° from vertical to obtain desired aiming angle.
Caution: Before making lamp angle adjustment, turn off fixture and allow lamp to cool.
Note: Trim will be locked in vertical position at factory. For vertical aiming, unlock yoke by loosening hex socket button
head cap screw with a
1
/
16
Allen wrench. See item 2 below for tightening and loosening.
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2010, 03/02/07 revision, All Rights Reserved - Printed in U.S.A.