Instruction sheet, Trim installation – Prescolite 79M_EB SERIES HOUSINGS User Manual

Page 2

Instruction

Sheet

www

.prescolite.com

Prescolite T

ollFree T

echnical Suppor

1.888.PRS.4TEC

Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Part No ....................................................... 93020673

Sheet 2 of 2

For Ballast replacement:

Note wire connections and remove ballast wire connectors. Loosen the (2) hex nuts holding the ballast to the J-Box. Slide ballast toward

opening in keyhole slots and lift ballast off J-Box. Replace ballast by following these steps in reverse order.

CAUTION: Do not attempt to modify or rewire factory installed wiring on the fixture. Safety and proper operation of the fixture depend on

the integrity of the wiring.

The product must be installed by a person familiar with the construction and operation of the product and the hazards involved, in accor-

dance with the applicable installation code.

KEEP THESE INSTALLATION INSTRUCTIONS

TRIM INSTALLATION

ST832 TRIM

1. Adjust socket bracket to proper position by loosening wing nut.

PAR 30 Lamps: Slide bracket to lowest (towards aperture) position.

PAR 38 Lamps: Slide bracket to highest (away from aperture) position..

2. Tighten wing nut securely.

3. Install lamp.

4. Locate trim clip retaining holes on lip of plaster flange. Attach trim retaining clips (3) to plaster

flange.

5. Press trim into aperture.