Prescolite 79 SERIES - Manual (Page 2)

www
.prescolite.com
•
Prescolite
T
ollFree
T
echnical
Support
1.888.PRS.4TEC
•
Hours:
8am
-
5pm
ET
101 Corporate Drive, Suite L • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2004, 08/04 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06268800
Instruction
Sheet
PLUG-
BALLAST
WARNING: CAP OFF
UNUSED 120V OR 347V
LINE
GREEN GROUND
BLACK LINE
(120V OR 277)
CONNECT 277V TO TP OR
120V TO TP DEPENDING ON
SUPPLY
WIRE DIAGRAM 120V WITH 347V
WHITE COMMON
GREEN GROUND
WHITE COMMON
BLACK LINE (120)
ORANGE LINE (347v)
WIRE DIAGRAM 120V WITH 277V
BALLAST
BALLAST PLUG-JBOX
PLUG-JBOX
PLUG-
BALLAST
NOTE: BE SURE TO CONNECT THE PLUG FROM THE BALLAST WITH THE PLUG FROM THE J-BOX.
TRIM INSTALLATION
920 TRIM:
1. ADJUST SOCKET BRACKET TO PROPER POSITION BY LOOSENING WING NUT.
PAR 30 LAMPS: SLIDE BRACKET TO LOWEST (TOWARDS APERTURE) POSITION.
PAR 38 LAMPS: SLIDE BRACKET TO HIGHEST (AWAY FROM APERTURE) POSITION.
2. TIGHTEN WING NUTSECURELY.
3. INSTALL TRIM BY LOCATING COIL SPRINGS IN SLOTS ON HOUSING.
4.INSTALL LAMP.
832, 833 AND 834 TRIMS:
1. ADJUST SOCKET BRACKET TO PROPER POSITION BY LOOSENING WING NUT.
PAR 30 LAMPS: SLIDE BRACKET TO LOWEST (TOWARDS APERTURE) POSITION.
PAR 38 LAMPS: SLIDE BRACKET TO HIGHEST (AWAY FROM APERTURE) POSITION.
2. TIGHTEN WING NUTSECURELY.
3. INSTALL LAMP.
4. LOCATE TRIM CLIP RETAINING HOLES ON LIP OF PLASTER FLANGE. ATTACH TRIM
RETAINING CLIPS (3) TO PLASTER FLANGE.
5. PRESS TRIM INTO APERTURE.
JBOX
JBOX