beautypg.com

Prescolite 84XCP User Manual

Ins tru ctio n s he et, Installation instructions 84xcp

background image

Ins

tru

ctio

nS

he

et

w
w
w

.p

r

e

s

c

o

li

te

.c

o

m

•P

res

co

lite

To

llF

ree

Te

ch

nic

al

Su

pp

ort

1.8

88

.P

RS

.4T

EC

Ho

urs

:8

am

-5

pm

ET

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .124430100

Ins

tru

ctio

nS

he

et

INSTALLATION INSTRUCTIONS

84XCP

ADJUSTABLE

MOUNTING

BRACKET

CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER

OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.

HOUSING

J-BOX COVER

PLASTER FLANGE

THICK CEILING

ADJUSTMENT

SCREW (3)

1. Install the fixture in the ceiling using mounting channel, bar stock or 1/2" rigid conduit placed in the adjustable mounting brackets. The

fixture should be installed in such a manner that the weight of the fixture is supported by the mounting channels/bar stock/rigid conduit

and/or hanger wires secured to the building structure.

2. Adjust the fixture so the bottom edge of the plaster flange is flush with the ceiling line by sliding the mounting brackets and secure

using adjusting screws. Housing may be lowered further to compensate for thick ceilings by use of the (3) thick ceiling adjusting

screws.

3. Remove J-Box cover plate. Remove appropriate knockout and assemble appropriate connector for the supply wire used. Connect

ground wires to green ground leads. Connect white (common) to white (leads). Connect power supply (line) to black lead(s). Reinstall

J-Box cover.
WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a Qualified Electrician for all other options

that require other wiring configurations.

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information

and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,

and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and

during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by

qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.

Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in

compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by

the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from

product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or

the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.

701 Millennium Boulevard • Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Copyright 2007, 02/07 revision, All Rights Reserved - Printed in U.S.A.