Prescolite MC10LED CYLINDER SURFACE/CEILING MOUNT - Manual (Page 2)

In
s
tr
u
c
tio
n
S
h
e
e
t
Part No...........................................
With representatives offices in principal cities throughout North America.
Copyright , revision, All Rights Reserved - Printed in U.S.A.
701 Millennium Blvd • Greenville, SC 29607
w
w
w
.p
re
s
c
o
lit
e
.c
o
m
P
re
s
c
o
lit
e
T
o
ll
F
re
e
T
e
c
h
n
ic
a
l S
u
p
p
o
rt
1
.8
8
8
.P
R
S
.4
T
E
C
H
o
u
rs
: 8
a
m
-
5
p
m
E
T
93052567
2014 02/24/14
5. Carefully flip the cylinder upright and lift the
cylinder up to the mounting channel
assembly. Feed the fixture leads through the
threaded hole in the center of the fixture top
assembly. Engage the running thread, and
rotate the assembly a few times, being sure
that the fixture rotates freely and is not
cross-threading (Fig. 3). Pull the fixture
leads out though the wiring compartment
opening. Make sure they hang freely (don’t
rotate or twist), and thread the fixture onto
the running thread until the canopy contacts
the ceiling. Tighten the thread clamp screw
to lock the fixture assembly onto the running
thread. (Fig. 4)
WARNING: Failure to tighten the thread
clamp screw to lock the fixture assembly
onto the running thread may allow the
fixture to turn and fall!
6. Make the electrical connections in the fixture
wiring compartment. The line voltage (Black)
wire connects to the two-position connector
with the Red thermal protector wire. The
neutral (White) wire attaches to the empty
position on the connector with the White
wires. If provided, connect the Violet and
Gray control wires to an empty position on
the respective connectors with Violet and
Gray wires.
CAUTION: When making these
connections, be careful that no stray
strands of wire stick out of the
connectors that might cause electrical
shorts!
7. After the electrical connections are
completed, replace the wiring compartment
cover and tighten the thumbscrews to
complete the wiring of the fixture.
8. Once again loosen (do not remove) the two
Phillips screws on opposite sides of the
cylinder until the cylinder housing is free to
slide. Slide MC10LED outer cylinder housing
upwards until it seats on the finned casting.
CAUTION: Do not pinch any wires
between the cylinder housing and any
other parts of the fixture!
9. Be sure the cylinder housing is completely
seated, and tighten the two Phillips screws to
lock the cylinder housing in place.
Note: If the cylinder housing does not fully
seat when closing, you may need to loosen
the screws a little more to slide it closed.
This will allow the ends of the screws to pass
the locking slots at the very end of the slide
travel (Fig. 5).
Fig. 3
ROTATE
FIXTURE
LEADS IN
WIRING
COMPARTMENT
Fig. 4
FIXTURE
LEADS
THREAD
CLAMP
SCREW
RUNNING
THREAD
Fig. 5
SLIDE
HOUSING
CLOSED
PHILLIPS
SCREW
(1 OF 2)
LOCKING
SLOT
RUNNING
THREAD
KEEP THESE INSTALLATION INSTRUCTIONS!