Pololu USB AVR User Manual
Page 37
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 0.05s
avrdude: verifying ...
avrdude: 224 bytes of flash verified
avrdude: safemode: Fuses OK
avrdude done. Thank you.
rm BlinkLED.o BlinkLED.obj
This output indicates the AVR was successfully programmed. The LED connected to PD1 of your AVR should now
be flashing! Note that if you are trying this on a 3pi robot and you have not yet soldered in the optional through-
hole LEDs, the flashing LED will be on the bottom of the robot. If there was a problem, please see Troubleshooting
(
) for help identifying and fixing it.
Pololu USB AVR Programmer User's Guide
© 2001–2014 Pololu Corporation
4. Getting Started in Linux
Page 37 of 54