Opticon OPN 2002 v35315 Bluetooth demo Quick Guide - Manual (Page 7)

7
Connect as slave
When you want a remote Bluetooth device to connect with your OPN2002, then it is not
necessary to configure the remote Bluetooth address, but you will have to make your
OPN2002 discoverable and connectable to allow the remote device to find and connect to
your OPN2002.
To make your OPN2002 discoverable and connectable for 2 minutes, keep the small clear
key pressed for 5 seconds until the blue LED starts blinking. After that you should let your
remote device discover all Bluetooth devices in range to find your OPN2002.
Screenshot of discovered Bluetooth devices.
After you've successfully discovered your OPN2002 you can try to let your remote device
pair with your OPN2002.
If you haven't disabled authentication on your remote device, then you will be requested to
enter a PIN code (or passkey) on your remote device. The default PIN code of the
OPN2002 equals the last 4 digits of the Bluetooth address. These last 4 digits of the
Bluetooth address are also shown in the Bluetooth name of the OPN2002. If you wish to
use a different PIN code, then this is possible by using the 'Set/End PIN-code label' menu
options, which can be found in chapter 2.3.2 of the Universal menu book.