Memmert CELSIUS 10 FDA - Manual (Page 9)

9
CELSIUS 10 FDA-Edition
§8 - CHOICE OF LAW
All legal relations between the parties, including delict law, are subject to the law of the Ger-
man Republic. The legal domicile is Schwabach, Germany.
§9 - FINAL CLAUSE
1) Supplements to this agreement, including this clause, have to be produced in writing.
2) If one or several of the above terms should be or become invalid, this does not affect the
effectiveness of the other terms. The invalid term is to be replaced by a valid term which as far
as possible realizes the intended commercial purpose This also applies in case of a gap in the
agreement.
3) This agreement is subject to the law of the German Republic. Legal domicile is the domicile
of the licensor. All questions relating to the validity, interpretation and performance of the
contents of this agreement should be clarified at the legal domicile of the licensor in the Ger-
man Republic.
2. Introduction
2.1 Description
2.1.1 Basic programme functions
CELSIUS is a computer programme for the programming, control and logging of MEMMERT
ovens with an RS-232, or alternatively RS-485, USB or Ethernet interface.
With CELSIUS, you can
►
Create, change and save tempering profiles on your computer in graphical or tabular
form.
►
Control one or more MEMMERT ovens via one or more serial interfaces and log the current
values. up to eight ovens can be controlled via RS-232 or USB, and if RS-485 or Ethernet
interfaces are used (not for ovens of the E class), you can control up to 16 ovens simulta-
neously;
►
if your oven is equipped accordingly, you can use the functions of the MEMoryCard XL,
i. e. to store a tempering profile on a MEMoryCard XL, as well as load tempering profiles
and protocols from a MEMoryCard XL, display this on the monitor and save it to a differ-
ent data medium (hard drive, USB stick);
►
read out, manage and document the internal ring protocol memory (1024 kB) of the
MEMMERT ovens;
►
print out tempering profiles and accompanying protocol data (depending on the oven
type, temperature, humidity, vacuum, CO
2
, O
2
, fan speed, air flap position and switch
contacts, see page 7 ) including GLP data, graphically or numerically.