Memmert CELSIUS 10 FDA - Manual (Page 34)

34
CELSIUS 10 FDA-Edition
What setting options are available depends on what oven type is used for a tempering profile.
The setting options for individual oven types are listed from page 7 .
With "Edit" →"Undo" or , the last performed entry / change can be revoked.
8.1.3 Device status line
The device status line is visible at the top of the graphical and tabular views while a tempering
profile is being created or run. It shows the following information:
Controller active COM3 IST: 24.1 °C 40.1 °C 0:02h
1 2 3 4 5
1 Controller status, e.g.:
►
Edit Profile The tempering profile can currently be edited.
►
starts at ...: Time at which the controller starts
►
Controller active: The controller is currently controlled by the PC. At the
temperature curve, nothing can be changed.
►
Controller passive: The programme sequence was interrupted by a pause in the Run
menu.
►
STOP: The programme, and thus the controller, was stopped.
To edit the tempering profile, the menu item "Wrap-Up
Profile" in the "Edit" menu must be selected.
►
ERROR : The controller has reported an error state.
The corresponding error text is displayed.
2 COM interface of oven or "offline"
3 Actual temperature value
4 Physical properties of the oven at the mouse position while a tempering profile is being
run (e. g. temperature, humidity, vacuum) or the temperature at the mouse cursor position
4 Physical properties of the oven at the mouse position while a tempering profile is being 4 Physical properties of the oven at the mouse position while a tempering profile is being
while the temperature profile is being entered
run (e. g. temperature, humidity, vacuum) or the temperature at the mouse cursor position run (e. g. temperature, humidity, vacuum) or the temperature at the mouse cursor position
5 Current runtime or the time coordinates at the mouse cursor position while the tempera-
ture profile is being entered
5 Current runtime or the time coordinates at the mouse cursor position while the tempera- 5 Current runtime or the time coordinates at the mouse cursor position while the tempera-
The device status line can be switched on and off in the Settings menu.
8.1.4 Working in the graphical view
The graphical view of a tempering profile can be displayed
►
with the icon in the toolbar
►
via "View" →"Graphics" in the menu bar
The graphics window is divided into horizontal segments, depending on the oven type. In the
top segment (1), a tempering profile can be created, and the temperature is logged when a
tempering profile is executed. In the lower segment (2), other oven-specific parameters (e.g.
humidity, vacuum) can be programmed and logged. What these are specifically can be seen in
the table on page 7 .