Memmert CELSIUS 10.0 - Manual (Page 3)

3
CELSIUS 10.0
About this manual
Intended use and target group
This user manual describes the installation and use of the MEMMERT control software CEL-
SIUS 10.0. It is intended for use by trained personnel of the operating company, who have the
task of programming/operating MEMMERT ovens.
If you intend to work with the software, please read this manual carefully before starting.
Familiarise yourself with the programme and run several tests before actually controlling an
oven. Incorrect use could result in damage to the oven and/or to the chamber load.
If there is something you do not understand, or certain information is missing, ask your supe-
rior or get in touch with the manufacturer. Do not do anything without authorisation.
Explanation of terms
Below, we shall explain a number of terms that are used repeatedly in this manual.
Term Meaning
Description
on/from page
Tempering
profile/ramp
a time sequence of physical values/combinations
(temperature and – depending on oven type – hu-
midity, vacuum, CO
2
and O
2
), that the oven should
perform
27
Protocol Recording of the actual physical values/combinations
(temperature and – depending on oven type – humid-
ity, vacuum, CO
2
and O
2
), that the oven should create
during the execution of a tempering profile (measur-
ing values)
38
Controller internal control of an oven
Other documents that you must read:
Please also read the user manual for the respective oven to be operated with the software
and familiarise yourself with it.
Storage and forwarding
This manual should always be kept in a place where those working with the software have
access to it. It is the responsibility of the operator to ensure that persons who work with or
will work with the software are informed as to the whereabouts of this user manual. We rec-
ommend that it is always stored in a protected location close to the computer on which the
software is installed. Make sure that the manual is not damaged by heat or damp.
An electronic version of this manual in PDF format can be run from the software via the
help function (see page 19 ).