Lenze E84Dxxxxx - Manual (Page 49)

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05
49
6 Safe parameter transfer
6.6 Password management
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.6 Password management
For a safe parameter transfer, the device password must be entered.
• For initial commissioning, the standard password "Lenze SM301" has to be used as device
password.
• The Change Password function serves to define an individual device password.
Change Password
This function serves to define an individual device password.

How to change the device password:
1. Unless there is an online connection, establish an online connection to the device.
2. Go to the advanced Safe transfer dialog box and enter the new password into the New
Password input field.
• The password must have at least 6 characters.
3. For verifying the new password re-enter it into the Verify Password input field.
• Only if this input matches the input in the New Password input field, the password can
be changed.
4. Click the Change Password button.
If you are not yet registered as a user, first the Password entry dialog box is displayed.
5. Enter the device password and confirm with OK.
• Unless an individual password has been defined, enter the standard password "Lenze
SM301".
After log-on the password is changed and then a status message displays whether the
action could be carried out successfully.
6. Confirm the status message with OK.

Note!
After the password has been entered, you are registered as a user for a time period of 30
minutes.
• Within this period, the password does not need to be entered again for calling a
password-protected function if the online connection to the device remains
established without any interruptions.
• The status of registration is displayed in the bottom right corner of the Safe transfer
dialog box.
• Click the Logout User button to log out before the 30 minutes have elapsed.