Lenze IMSS500+ Simple Servo 500 600 i1000 User Manual

Page 44

Text mode
Original mode

SimpleServo 500/600/i1000 User Manual Rev 3.4

Note
Each Hall Voltage will be in phase with one and only one Output Voltage.

B leads A for CW.

This is encoder phase relationship for CW/CCW shaft rotation. When you obtain the diagram for
your motor phasing similar to shown above, it’s assumed by software that motor shaft rotating CW
when looking at the mounting face of the motor. . For that rotation Encoder phase A must lead
phase B. If it does leave check box unchecked. Otherwise (if B leads A ) check B leads A for CW
box.

Note

Some manufacturers’ timing diagrams are CW when viewed from the “rear” of the motor
(not from shaft!).