Lenze E94P PositionServo with MVOB - Manual (Page 96)

94 L S94H201E_13426446_EN
Diagnostics
Display Description
dHCP Ehternet DHCP Configuration: 0=”dHCP” is disabled; 1=”dHCP is enabled.
IP_4 IP Adress Octet 4
IP_3 IP Adress Octet 3
IP_2 IP Adress Octet 2
IP_1 IP Adress Octet 1
ptc Displays the motor ptc resistance in ohms
ain1 Displays the voltage on Drive Analog Input 1 (Ain1)
ain2 Displays the voltage on Drive Analog Input 2 (Ain2)
8.2 Diagnostic LEDs
The PositionServo has five diagnostic LEDs located around the periphery of the front panel display as shown
in the drawing below. These LEDs are designed to help monitor system status and activity as well as
troubleshoot any faults.
S913
LED Function Description
A Enable Orange LED indicates that the drive is ENABLED (running).
B Regen Yellow LED indicates the drive is in regeneration mode.
C Data Entry Yellow LED will flash when changing.
D Comm Fault Red LED illuminates upon a communication fault. (in CANbus only)
E Comm Activity Green LED flashes to indicate communication activity.
8.3 Stop/Reset
With hardware version 2 and higher, MotionView OnBoard (MVOB) features a [Stop/Reset] action dutton in
the top right-hand corner. Pressing the red [Stop/Reset] button causes all motion to stop and resets the
drive.
Stop/Reset Button