Lenze E94P PositionServo with MVOB - Manual (Page 7)

S94H201E_13426446_EN L 5
Introduction
1 Introduction
1.1 Safety Information
The safety information provided in this documentation has the layout shown herein.
Signal Word! (Characteristics the severity of the danger)
Note (describes the danger and informs on how to proceed)
Table 2: Pictographs used in these Instructions
Icon Signal Words
Warning of
hazardous
electrical voltage DANGER! Warns of impending danger.
Consequences if disregarded:
Death or severe injuries.
Warning of a
general danger WARNING! Warns of potential, very hazardous situations.
Consequences if disregarded:
Death or severe injuries.
Warning of
damage to
equipment STOP! Warns of potential damage to material and
equipment.
Consequences if disregarded:
Damage to the controller/drive or its environment.
Information NOTE Designates a general, useful note.
If you observe it, handling the controller/drive system is
made easier.
1.2 Legal Regulations
Table 2 lists the identification, application, liability, warranty and disposal information for the PositionServo
drive.
Table 3: Legal Disclaimers
Claim Description
Identification Nameplate CE Identification Manufacturer
Lenze controllers are unambiguously
designated by the contents of the
nameplate In compliance with the EC
Low-Voltage Directive Lenze AC Tech Corporation
630 Douglas Street
Uxbridge, MA 01569 USA
Application
as directed E94P or E94R servo controller
• must only be operated under the conditions prescribed in these Instructions.
• are components for:
- Closed loop control of Velocity, Torque, or Positioning applications with AC synchronous motors.
- installation in a machine.
- assembly with other components to form a machine.
• are electric units for installation in control cabinets or similarly enclosed housing.
• comply with the requirements of the Low-Voltage Directive.
• are not machines for the purpose of the Machinery Directive.
• are not to be used as domestic appliances, but only for industrial purposes.
Application
as directed Drive systems with E94P or E94R servo inverters
• comply with the EMC Directive if they are installed according to the guidelines of CE-typical drive
systems.
• can be used for:
- for operation on public and non-public mains
- for operation in industrial premises and residential areas.
• The user is responsible for the compliance of his application with the EC directives.
Any other use shall be deemed as inappropriate!
Note: Table 3 continued on next page.