Lenze EMF2181IB - Manual (Page 72)

Appendix
AT commands
Interface commands for the DEE modem
10
l
72 EDSMF2181IB EN 3.0
10.3.2 Interface commands for the DEE modem
Command: X
Extended result codes
Selects the subset of the result code messages used by the modem to inform the DEE about
the results of the commands. Blind dialling is activated or deactivated by the country
parameters. If the user wants to force a dial tone detection, a "W" can be inserted in the
character string to be selected. (See D−command, not described in this manual). The
information below is based on the standard version of the X result table. If the modem is
in the "Facsimile" operating mode (+FCLASS=1, 1,0, or 2), CONNECTED without a speed
display is the only message being transmitted to indicate a connection.
Command Default
setting Values defined Result codes
X 4 X0 Deactivates the signalling of busy signals if this is not
forced in the country requirements; only sends OK,
CONNECT, RING, NO CARRIER, ERROR, and NO
ANSWER result codes. Blind dialling is
activated/deactivated by the country parameters. If
the function for busy signal detection is activated and
a busy signal is detected, NO CARRIER is signalled. If
the function for dial tone detection is activated or
selected and no dial tone is detected, NO CARRIER
instead of NO DIAL TONE is signalled. The value 000b
is rewritten to S22 bits 6, 5, and 4, respectively. OK
otherwise ERROR
X1 Deactivates the signalling of busy signals if this is not
forced in the country requirements; only sends OK,
CONNECT, RING, NO CARRIER, ERROR, NO ANSWER,
and CONNECT XXXX (XXXX = rate). Blind dialling is
activated/deactivated by the country parameters. If
the function for busy signal detection is activated and
a busy signal is detected, NO CARRIER instead of BUSY
is signalled. If the function for dial tone detection is
activated or selected and no dial tone is detected, NO
CARRIER instead of NO DIAL TONE is signalled. The
value 100b is rewritten to S22 bits 6, 5, and 4,
respectively.
X3 Activates the signalling of busy signals; only sends
OK, CONNECT, RING, NO CARRIER, ERROR, NO
ANSWER, and CONNECT XXXX. Blind dialling is
activated/deactivated by the country parameters. If
the function for dial tone detection is activated and
no dial tone is detected, NO CARRIER is signalled. The
value 110b is rewritten to S22 bits 6, 5, and 4,
respectively.
X4 Activates the signalling of busy signals; send all
messages. The value 111b is rewritten to S22 bits 6, 5,
and 4, respectively.